360 Wig, (also named 360 lace wigs and 360 frontal wigs), comes with a 360-degree lace sheer that goes around the head. The construction of the 360 Lace Wig makes it more flexible in styling, it allows the wearer to part anywhere and put it into a high ponytail. Besides, it is also available to bring a premium comfortable wearing experience while offering the most natural illusion.

 

How to make a 360 lace wig?

Step 1: Put on a wig cap and 360 lace frontal

Put the mesh wig cap on the mannequin's head. And then put the 360 Lace Front Wigs on and make sure the edges of the wig cap are completely covered by the 360 frontal. Pin the 360 frontal on the mannequin's head with some T-pins.

 

Step 2: Sew in 360 frontal

Comb down the hair strands of the 360 frontal, so that the lace edges of the frontal can be exposed completely. Cut off the excess lace with the scissors. Use thread and needle to sew the 360 lace frontal into the mesh cap.

 

Step 3: Sew in human hair bundles

Start at the back of the frontal and anchor the bundles into the wig cap with a double knot. Sew in a bundle along the back lace edges of the 360 frontal. Once you reach the opposite of the 360 frontal fold the bundle up and continue to sew the next line. Continue to sew in until you finish a full head sew-in.

 

Step 4: Pluck the wig

Use a tweezer to remove the excess hair strands along the hairline to make your wig look more natural. Use a pair of scissors to cut off the excess lace on the back. 

 

Step 5: Sew in combs or clips

Turn the wig inside out and sew down two combs on each side with thread and needle. And you can also choose to sew an elastic band at the back of the wig, so you can put this 360 wig on without applying any glue.